************************************
* SK-LPC2478-S3E development board *
* www.starterkit.ru *
************************************
Booting (may take some time)...


U-Boot 1.1.6 (Jan 8 2008 - 07:46:34)

DRAM: 32 MB
Flash: 500 kB
NAND: 256 MiB
*** Warning - bad CRC, using default environment

In: serial
Out: serial
Err: serial
Hit any key to stop autoboot: 0

Booting from NAND FLASH (may take some seconds)
First loads linux.bin and then romfs.bin

NAND read: device 0 offset 0x0, size 0x300000
3145728 bytes read: OK

NAND read: device 0 offset 0x300000, size 0x400000
4194304 bytes read: OK
## Starting application at 0xA0008000 ...
Linux version 2.6.11.8-hsc0 (root@uClinux) (gcc version 2.95.3 20010315 (release)(ColdFire patches - 20010318 from http://fiddes.net/coldfire/)(uClinux XIP and
shared lib patches from http://www.snapgear.com/)) #39 Tue Jan 8 09:45:22 EST 2008
CPU: Philips-lpc24xx [24000000] (ARMv3)
Machine: LPC24xx, NXP
Warning: bad configuration page, trying to continue
Built 1 zonelists
Kernel command line: root=/dev/ram rw initrd=0xa1800000,4000k console=ttyS0,115200N8
PID hash table entries: 256 (order: 8, 4096 bytes)
Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)
Inode-cache hash table entries: 4096 (order: 2, 16384 bytes)
Memory: 32MB = 32MB total
Memory: 26248KB available (1881K code, 180K data, 80K init)
Mount-cache hash table entries: 512 (order: 0, 4096 bytes)
checking if image is initramfs...it isn't (bad gzip magic numbers); looks like an initrd
Freeing initrd memory: 4000K
NET: Registered protocol family 16
SCSI subsystem initialized
usbcore: registered new driver hub
NetWinder Floating Point Emulator V0.97 (double precision)
JFFS2 version 2.2. (NAND) (C) 2001-2003 Red Hat, Inc.
yaffs Jan 8 2008 09:45:10 Installing.
Serial: 8250/16550 driver $Revision: 1.90 $ 1 ports, IRQ sharing disabled
yttyS0 at MMIO 0x0 (irq = 6) is a 16550A
io scheduler noop registered
io scheduler deadline registered
RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize
loop: loaded (max 8 devices)
NFTL driver: nftlcore.c $Revision: 1.97 $, nftlmount.c $Revision: 1.40 $
NAND: INIT
NAND device: Manufacturer ID: 0xec, Chip ID: 0xda (Samsung NAND 256MiB 3,3V 8-bit)
Scanning device for bad blocks
Creating 2 MTD partitions on "NAND 256MiB 3,3V 8-bit":
0x00000000-0x00800000 : "Kernel image"
0x00800000-0x10000000 : "Flash data"
NAND: LOADED OK
NAND: P4.17= READY
About to register ohci_hcd_lpc24xx_driver
About to register ip3506_ohci
ohci ohci1: at 0xffe0c000, irq 22
ohci ohci1: new USB bus registered, assigned bus number 1
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 1 port detected
Initializing USB Mass Storage driver...
usbcore: registered new driver usb-storage
USB Mass Storage support registered.
NET: Registered protocol family 2
IP: routing cache hash table of 512 buckets, 4Kbytes
TCP established hash table entries: 2048 (order: 2, 16384 bytes)
TCP bind hash table entries: 2048 (order: 2, 16384 bytes)
TCP: Hash tables configured (established 2048 bind 2048)
RAMDISK: romfs filesystem found at block 0
RAMDISK: Loading 3350KiB [1 disk] into ram disk... done.
VFS: Mounted root (romfs filesystem) readonly.
Freeing init memory: 80K
Welcome to
____ _ _
/ __| ||_|
_ _| | | | _ ____ _ _ _ _
| | | | | | || | _ | | | | / /
| |_| | |__| || | | | | |_| |/
| ___\____|_||_|_| |_|\____|\_/\_/
| |
|_|

For further information check:
http://www.uclinux.org/




Using /drivers/lpc2468eth.ko
emac: detect KS8721 PHY address 0x19
emac: found Micrel KSZ8721 PHY
emac: MAC address = 00:1a:f1:00:00:01:
Using /drivers/lpc2468mmc.ko
mci-cid (SD memory card):
Manufacturer ID: 0x1a
OEM/Application ID: PQ
Product Name:
Product Revision: 0.0
Serial Number: 0x00500521
Date Code: 2007.1
sector size = 512 (Bytes), card size = 1001 (MBytes)

dump csd data: 002f01325f5983b9
f6dbdfff9e4000f4
mmc: unknown partition table
Using /drivers/adc.ko
Using /drivers/i2c.ko
Using /drivers/pwm.ko
Using /drivers/sfr.ko
Using /drivers/rtc.ko
Using /drivers/spi.ko
mmc: unknown partition table
mount: Mounting /dev/mmca1 on /mnt/mmc failed: No such device or address
SIOCGIFFLAGS: Inappropriate ioctl for device
SIOCGIFFLAGS: Inappropriate ioctl for device
SIOCGIFFLAGS: Inappropriate ioctl for device
SIOCGIFFLAGS: Inappropriate ioctl for device
yaffs: dev is 32505857 name is "mtdblock1"
yaffs: Attempting MTD mount on 31.1, "mtdblock1"
#

usb 1-1: new full speed USB device using ohci and address 2
scsi0 : SCSI emulation for USB Mass Storage devices
Vendor: KINGMAX Model: USB Flash Disk Rev: 2.00
Type: Direct-Access ANSI SCSI revision: 02
sda: Unit Not Ready, sense:
: Current: sense key=0x6
ASC=0x28 ASCQ=0x0
SCSI device sda: 1024000 512-byte hdwr sectors (524 MB)
sda: assuming Write Enabled
sda: assuming drive cache: write through
SCSI device sda: 1024000 512-byte hdwr sectors (524 MB)
sda: assuming Write Enabled
sda: assuming drive cache: write through
sda: sda1
Attached scsi removable disk sda at scsi0, channel 0, id 0, lun 0