Не монтируется почему то КФС с SD карты искал по форуму но не нашел что помогло! причем когда эту же SD карту подключаю через usb адаптер то КФС монтируется
параметры ядра при загрузке с SD :
bootargs=console=ttyS0,115200 root=/dev/mmcblk0 rootwait
вот лог:
NAND read: device 0 offset 0x60000, size 0x780000
7864320 bytes read: OK
## Booting kernel from Legacy Image at 20400000 ...
Image Name: Linux Kernel Image
Image Type: ARM Linux Kernel Image (gzip compressed)
Data Size: 1689855 Bytes = 1.6 MB
Load Address: 20008000
Entry Point: 20008000
Verifying Checksum ... OK
Uncompressing Kernel Image ... OK
Starting kernel ...
Linux version 2.6.28 (root@vm) (gcc version 4.2.0 20070413 (prerelease) (CodeSourcery Sourcery G++ Lite 2007q1-10)) #53 Mon Jun 24 09:15:59 MSD 2013
CPU: ARM926EJ-S [41069265] revision 5 (ARMv5TEJ), cr=00053177
CPU: VIVT data cache, VIVT instruction cache
Machine: Starterkit.ru SK-AT91SAM9XXXXX-SIMXXX
Memory policy: ECC disabled, Data cache writeback
Clocks: CPU 200 MHz, master 100 MHz, main 12.000 MHz
Built 1 zonelists in Zone order, mobility grouping on. Total pages: 8128
Kernel command line: console=ttyS0,115200 root=/dev/mmcblk0 rootwait
AT91: 96 gpio irqs in 3 banks
PID hash table entries: 128 (order: 7, 512 bytes)
Console: colour dummy device 80x30
console [ttyS0] enabled
Dentry cache hash table entries: 4096 (order: 2, 16384 bytes)
Inode-cache hash table entries: 2048 (order: 1, 8192 bytes)
Memory: 32MB = 32MB total
Memory: 28952KB available (3140K code, 230K data, 116K init)
Calibrating delay loop... 99.73 BogoMIPS (lpj=498688)
Mount-cache hash table entries: 512
CPU: Testing write buffer coherency: ok
net_namespace: 288 bytes
NET: Registered protocol family 16
SCSI subsystem initialized
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 1024 (order: 1, 8192 bytes)
TCP bind hash table entries: 1024 (order: 0, 4096 bytes)
TCP: Hash tables configured (established 1024 bind 1024)
TCP reno registered
NET: Registered protocol family 1
NetWinder Floating Point Emulator V0.97 (double precision)
JFFS2 version 2.2. (NAND) (SUMMARY) б╘ 2001-2006 Red Hat, Inc.
yaffs Mar 27 2010 12:35:28 Installing.
msgmni has been set to 56
io scheduler noop registered (default)
atmel_usart.0: ttyS0 at MMIO 0xfefff200 (irq = 1) is a ATMEL_SERIAL
atmel_usart.1: ttyS1 at MMIO 0xfffb0000 (irq = 6) is a ATMEL_SERIAL
atmel_usart.2: ttyS2 at MMIO 0xfffb8000 (irq = 8) is a ATMEL_SERIAL
brd: module loaded
loop: module loaded
ssc ssc.0: Atmel SSC device at 0xc2878000 (irq 14)
MACB_mii_bus: probed
eth0: Atmel MACB at 0xfffc4000 irq 21 (00:1f:f2:00:00:00)
eth0: attached PHY driver [Generic PHY] (mii_bus:phy_addr=ffffffff:01, irq=-1)
Driver 'sd' needs updating - please use bus_type methods
NAND device: Manufacturer ID: 0xec, Chip ID: 0xda (Samsung NAND 256MiB 3,3V 8-bit)
Scanning device for bad blocks
Bad eraseblock 87 at 0x00ae0000
Bad eraseblock 163 at 0x01460000
Bad eraseblock 261 at 0x020a0000
Bad eraseblock 688 at 0x05600000
Bad eraseblock 719 at 0x059e0000
Bad eraseblock 1080 at 0x08700000
Creating 2 MTD partitions on "atmel_nand":
0x00000000-0x00800000 : "Partition 1"
0x00800000-0x10000000 : "Partition 2"
atmel_spi atmel_spi.1: Atmel SPI Controller at 0xfffcc000 (irq 13)
usbmon: debugfs is not available
ohci_hcd: USB 1.1 'Open' Host Controller (OHCI) Driver
at91_ohci at91_ohci: AT91 OHCI
at91_ohci at91_ohci: new USB bus registered, assigned bus number 1
at91_ohci at91_ohci: irq 20, io mem 0x00500000
usb usb1: configuration #1 chosen from 1 choice
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 2 ports detected
Initializing USB Mass Storage driver...
usbcore: registered new interface driver usb-storage
USB Mass Storage support registered.
udc: at91_udc version 3 May 2006
mice: PS/2 mouse device common for all mice
i2c /dev entries driver
i2c-gpio i2c-gpio: using pins 55 (SDA) and 56 (SCL)
usbcore: registered new interface driver usbhid
usbhid: v2.6:USB HID core driver
Advanced Linux Sound Architecture Driver Version 1.0.18rc3.
tlv320aic23b spi1.0: tlv320aic23b: supported bitrate is 47348 (66 divider)
mmc0: host does not support reading read-only switch. assuming write-enable.
mmc0: new SD card at address 1234
mmcblk0: mmc0:1234 SA02G 1.85 GiB
mmcblk0:<7>mmc0: starting CMD18 arg 00000000 flags 000000b5
ALSA device list:
#0: AT91SAM9260 external CODEC on irq 14
TCP cubic registered
NET: Registered protocol family 17
unknown partition table
RPC: Registered udp transport module.
RPC: Registered tcp transport module.
yaffs: dev is 187695104 name is "mmcblk0"
yaffs: passed flags ""
yaffs: Attempting MTD mount on 179.0, "mmcblk0"
yaffs: dev is 187695104 name is "mmcblk0"
yaffs: passed flags ""
yaffs: Attempting MTD mount on 179.0, "mmcblk0"
List of all partitions:
1f00 8192 mtdblock0 (driver?)
1f01 253952 mtdblock1 (driver?)
b300 1943552 mmcblk0 driver: mmcblk
No filesystem could mount root, tried: ext2 cramfs vfat msdos yaffs yaffs2
Kernel panic - not syncing: VFS: Unable to mount root fs on unknown-block(179,0) |
03.07.2013 09:59
